skip to content
System Design in the Smoking Room

I fucking hate 3D printers

/ 2 min read

Table of contents

Right now I’m sitting with a can of cider, contemplating why I brought this upon myself.

I could have chosen knitting, brewing, baking, drawing and god knows what else. But no, I chose fucking 3D printing in its worst and final form - open source.

Don’t get me wrong, I love open source, whether it’s software or hardware. But every time I decide to make something and later use it as a production tool, I never think about the goddamn consequences.

Fucking hotend. Do you know why I’m so frustrated? Let me show you some pictures.

Photo 1

Yes, it’s partially disassembled, but can you see the culprit? No? I’ll help you.

Photo 2

Maybe now? Let me put something next to it for scale. Sorry, no banana.

Photo 3

Yep, this little fucker. This tiny piece of plastic is the whole reason I’m writing this a bit drunk.

Photo 4

Just a tiny fucking piece of plastic that clogged the fucking hotend. Nothing special, just a random casual usual nothing-fucking-special clog. Yes, it has happened multiple times before, but this time everything decided to break at once.

Because of it I have already:

  • Reinstalled the whole Linux system because the SD card had been dying for quite some time (it was basically the start of the whole journey)

  • Fried (yes, I’m that stupid) my EBB SB2209 and replaced it with an EBB36. The hotend clogged and I tried to clear it. At some point I didn’t disconnect the power and caught some magic smoke…

  • Replaced the whole toolhead, from Stealthburner to A4T, because I had wanted to improve cooling for a while. And because I had an EBB36 lying around, I thought: why not replace the WHOLE toolhead? It will be so much fun (it’s not).

  • Found out that I fried my Cartographer board too (that level of stupid, yes). It happened at the same time I fried the CAN board.

  • Bought some random brass tube that has the right OUTER diameter but the wrong INNER one. And drilling out such a small tube is fucking awful, I must say. It’s needed for the A4T carriage. I’ve assembled around 4 printers before, and this is the first time I’ve seen something like this.

  • Spent like a whole day disassembling and reassembling this fucking printer

  • …

  • PROFIT (it’s not the end, you know)

And you know what? I still fucking love it.

Even though the Voron team made a new official alternative to Stealthburner1, and I think it would be much easier to assemble than A4T.

After all of this, I would still recommend that people build their own 3D printers, even though some commercially available printers are faster, cheaper and better in pretty much every category2.

And I cannot explain why.

Take care of yourselves and your loved ones!

Footnotes

  1. Shoutout to them, because they upgraded Stealthburner, made a new toolhead - Downdraft and made a new carriage for it - Chariot. ↩

  2. Please don’t quote me on this. I know that there are a lot of people who can make those printers a lot better than I do. For me it’s basically a skill issue. ↩